* Update docs for mod-morph
* Add unit tests for mod-morph
* Add keep-mods to DT binding
Co-authored-by: Martin Aumüller <aumuell@reserv.at>
Co-authored-by: Cem Aksoylar <caksoylar@users.noreply.github.com>
To combine multiple sticky modifiers, the sticky keys must ignore
other (sticky) modifier keypresses.
This behavior is important for "callum-style mods", where all modifiers
are sticky mods.
Fixes#829
* GATT characteristic allowing passng data + behavior
label to invoke the behavior on the peripheral side.
* Behaviors have a locality setting to specify where they run.
* Build reset/power/RGB on peripheral.
This is a generalization of the existing concept of tri-layer support
that's already well known. Essentially, a conditional-layer
configuration activates a particular layer (the then-layer) when one or
more other layers (the if-layers) are activated.
This is commonly used on ortho keyboards to activate a third "adjust"
layer while the primary two layers ("lower" and "raise") are active.
* Add optional `hold-trigger-key-positions` hold-tap configuration
* Leverage configuration for decision making around when to trigger
hold decision in hold-taps.
* Add docs for new configuration.
* Tests for the new config/decision logic.
* Use lesser-known DT features to skip behaviors not referenced
in the user keymap
* Update the behaviors to skip code if no nodes found.
* Remove some empty config/data structs where unused in
behaviors.
Tap-and-hold a hold-tap to hold the tap behavior so it can repeat.
After a tap, if the same key is pressed within `quick_tap_ms`, the
tap behavior is always picked.
This is useful for things like `&ht LSHFT BACKSPACE` where holding
the backspace is required.
Implements #288.
Added a new setting to remember the user's preferred endpoint. When both USB and
BLE are connected, the preferred endpoint will be used.
Added a new behavior to control this setting. It supports commands:
&end END_USB - Prefer USB output
&end END_BLE - Prefer BLE output
&end END_TOG - Toggle between USB and BLE
This PR adds support to control the external power output from controllers like nice!nano, nRFMicro etc
I have implemented based on my understanding of Pete suggestion on this feature.
Testing done:
Tested by enabling and disabling the ext_power from application and verified
Verified the application does not crash with boards that does not have ext_power support
Note:
I did not test this in nice!nano since I don't have the boards. Will get help from others once the behavior PR is up
Next Steps:
Create a behavior PR to control enable/disable ext_power
* Add `bt` behavior that can be used to perform certain actions,
such as next/prev identity, reset identity, etc.
NOTE: Multiple identities is only supported for non-split shields,
due to missing Zephyr identity functionality for dual
central/peripheral devices.
* Proper bond reset tied to action, that honors peripheral bonds,
so folks can reset and pair to other hosts, without breaking
bonds between splt halves.
Robert U
Nick Conway
Peter Johanson
Caleb Goates
Andrew Rae
Kurtis Lew
okke
Alessandro Bortolin
ReFil
Lucas Yunkyu Lee
Jonathan Rascher
jding
jmding8
Darryldh
Nick Winans
KemoNine
innovaker
KemoNine
Joel Spadin
Mega Mind