* Update underglow.md
Updated the documentation according to my current understandring of how to pin-mapping works, also split the chapter into a nrf-section and a non-nrf-section since that information isn't applicable to both
* Ran prettier and updated pin reference according to suggestion
This is an improvement on retro-tap, solving the 'flashing hold' issue
users people experience.
When the tapping-term expires, the hold key is normally pressed. When
retro-tap is enabled, this is undesirable; only an interrupted hold-tap
should trigger the hold behavior.
This change disables the hold behavior for the 'STATUS_HOLD_TIMER'
state when retro-tap is enabled, and makes sure the
'STATUS_HOLD_INTERRUPT' state will be triggered when appropriate.
* Public type for HSB led color.
* New API for calculating "next" HSB based on current
state.
* Update behavior to convert the increment/decrement
commands to absolute command as well.
Added a docs page with tips for setting up VS Code's code completion to work
in ZMK's source files. Info for other IDEs can be added here later as needed.
* feat(nibble): add underglow support for nice_nano builds
* feat(nibble): add encoder to top, left most column to match standard assembly documentation
* refactor(nibble): add layer labels
* feat(nibble): add support for optional display ; off by default
* feat(nibble): add README
* fix(nibble): adjust oled rotation for easier reading
* fix(nibble): add additional note about enabling oled
* refactor(nibble): convert keymap to use tabs instead of spaces
* refactor(nibble): enable oled in dts/overlay by default
* refactor(nibble): cleanup alignment and formatting in nibble keymap
* refactor(nibble): re-align top most row of keymap to be sensible
* refactor(nibble): cleanup kscan map alignment
* refactor(nibble): indent first row of map/transform to properly align with physical columns
* fix(nibble): remove dangling code block from readme
Co-authored-by: KemoNine <mcrosson@kemonine.info>
Add a little delay so any capacitors connected to the ADC for the BVD can charge up when using power_gpios
Co-authored-by: Jasper Smit <jrhrsmit@gmail.com>
* Use lesser-known DT features to skip behaviors not referenced
in the user keymap
* Update the behaviors to skip code if no nodes found.
* Remove some empty config/data structs where unused in
behaviors.
Tap-and-hold a hold-tap to hold the tap behavior so it can repeat.
After a tap, if the same key is pressed within `quick_tap_ms`, the
tap behavior is always picked.
This is useful for things like `&ht LSHFT BACKSPACE` where holding
the backspace is required.
Implements #288.
* Add easier macros for conditional polling/interrupt code.
* Properly continue polling on intervals, without extra
enable/disable code for pins that is superfluous when not trying to
deal with interupts firing.
* Fix to allow multiple GPIO drivers when doing splits w/ IO expanders
Updated docs for the build and flash to have similar content to the new board page.
Added a bit about DFU in case someone were searching for that term.
