PSDR/Hardware at 2e3f852f88dc2b93929fe7d036b7f2bf029a0675 - pwarren/PSDR

History

Michael Colton 2e3f852f88 Backing up. Cleaned up component placement a lot. Made moats around circuit blocks so there is room for vias. I also like the idea of the blocks being separated, maybe even labeled. I'll do it if I have room. Need to redo almost all of the routing, then I'll be ready to move the MCU into place and start hooking it up! Lots of work to do, but it's coming along very nicely :D.		2014-09-10 08:36:18 -06:00
..
Enclosure	Has the beginnings of an S-Meter. Audio seems worse than before that was added, so I want to check on that. Uploading the image files (even though the PSDR uses them in code form... still, might be handy)	2014-08-22 00:23:39 -06:00
Gerbers	Added PDF of schematic, and moved the gerbers a little.	2014-06-22 17:59:36 -06:00
Block Diagram.pdf	Added block diagram in a few formats. This is for the complete design, hopefully most/all of this will make it in the next board revision. Look at all that stuff!!	2014-08-11 23:05:17 -06:00
Block Diagram.png	Added block diagram in a few formats. This is for the complete design, hopefully most/all of this will make it in the next board revision. Look at all that stuff!!	2014-08-11 23:05:17 -06:00
Block Diagram.vsd	Looking at adding PJRC optimized display code to the PSDR. But his chip is rather different (no hardware FIFO) so I'll need to implement the changes with DMA I think, I'm sure it will work well, but it's going to be some work.... Update to block diagram. Also, finally getting to work on next rev of hardware!!	2014-08-23 14:08:17 -06:00
PSDR Schematic.pdf	Added PDF of schematic, and moved the gerbers a little.	2014-06-22 17:59:36 -06:00
PSDR.pcb	Backing up. Cleaned up component placement a lot. Made moats around circuit blocks so there is room for vias. I also like the idea of the blocks being separated, maybe even labeled. I'll do it if I have room. Need to redo almost all of the routing, then I'll be ready to move the MCU into place and start hooking it up! Lots of work to do, but it's coming along very nicely :D.	2014-09-10 08:36:18 -06:00
PSDR.sch	Backing up. Cleaned up component placement a lot. Made moats around circuit blocks so there is room for vias. I also like the idea of the blocks being separated, maybe even labeled. I'll do it if I have room. Need to redo almost all of the routing, then I'll be ready to move the MCU into place and start hooking it up! Lots of work to do, but it's coming along very nicely :D.	2014-09-10 08:36:18 -06:00
PSDR1_BOM.xlsx	Preliminary component placement is basically complete. Saving as a backup.	2014-09-07 18:24:50 -06:00
README.txt	Added PDF of schematic, and moved the gerbers a little.	2014-06-22 17:59:36 -06:00
STM32F429_Config.ioc	More progress on PSDR2. Schematic is basically complete (at least, all the components and blocks are in, though some connections between blocks and to the MCU are not in there yet.) Also started layout. Location sensitive components have been placed. It's going to be so cool!	2014-09-06 19:14:59 -06:00

README.txt

Schematics and Board layout files are for Mentorgraphics PADS.